Set Ip Address Switch Packet Tracer

Set Ip Address Switch Packet Tracer. Switch(config)#int fa0/1 Switch(configif)#switchport mode access Switch(configif)#switchport portsecurity Switch(configif)#switchport portsecurity macaddress sticky The sticky keyword instructs the switch to dynamically learn the MAC address of the currently connected host You can add these two optional commands.

Enable IPv6 Globally After going to the configuration mode with “configure terminal”Enable IPv6 on Interface After enabling IPv6 globally we should enable IPv6 under theConfigure EUI64 Format Global Unicast Address EUI64 format is the IPv6 format used toConfigure Manual Link Local Address If we do not use EUI64 format address we have toIPv6 Ping To check the connectivity between two node we use ping As IPv4 with IPv6 weManual Link Local Address Configuration To configure a Link Locak address manually weAuto IPv6 Address Configuration IPv6 Addresses can be configured automatically This isEnable DHCPv6 Client To enable DHCPv6 Client function on an interface we use “ipv6IPv6 Verification Commands To verify IPv6 Configuration we can use different show.

Solved: Packet tracer, Switch ip configuration Cisco

The “Ip address” command allows us to configure an IP address to the interface and a Subnet Mask Followed by “10001 2552552550” which is the IP address and the Subnet Mask.

Packet Tracer Lab 1 : Basic switch setup Packet Tracer

To configure the host as a DHCP client change the host’s IP configuration option to DHCP For this click the device and click the Desktop option and click the IP configuration and select the DHCP option The following image shows this procedure stepbystep on packet tracer.

Configure IP Address Settings on a Switch using the CLI

5 rowsStep 1 Cable the network as shown in the topology Step 2 Verify the default switch DEVICE INTERFACE IP ADDRESS / PREFIX IP Address / Prefix S1 VLAN 99 19216812 /24 19216812 /24 S1 VLAN 99 2001db8acad12 /64 2001db8acad12 /64 S1 VLAN 99 fe802 fe802 PCA NIC 192168110 /24.